Speaker Setup Guide; Safety Precautions When Setting Up; Home Theater Sound Setup; Standard Surround Setup - Pioneer SX-SW260 Operating Instructions Manual

Speaker Setup Guide

Chapter 1
Speaker Setup Guide

Safety precautions when setting up

When assembling the speakers, lay them down flat on
their side to avoid accidents or injury. Make sure to use a
stable surface when assembling, setting up, and placing
the speakers.

Home theater sound setup

Depending on the size and characteristics of your room,
you can place your speakers in one of two ways using this
system.

Standard surround setup

This is a standard multichannel surround sound speaker
setup for optimal 5.1 channel home theater sound.
Front
left
Center
Listening position
Surround
left
Listening position
1 Attach the smaller non-skid pads to the base of
each of the front, surround and center speakers. The
four large non-skid pads are for the receiver
subwoofer (as shown).
Use the adhesive side of the pads to attach them to the
base (flat surface) of each speaker.
Front
right
Receiver subwoofer
Surround
right
Non-skid pads
(large) x 4
2 Connect the speaker system.
Refer to Connecting up to connect the speakers properly.
After connecting everything, place the speakers as
shown in the diagram (left) for optimal surround sound.
After placing the speakers, run the Auto MCACC setup
(page 17) to complete your surround sound setup.
Front and surround speakers
Non-skid pads
(small) x 20
Center speaker
Receiver subwoofer
01
7
En