Table of Contents
Advertisement
Setting up Windows 2000/XP
Point
While setting up Windows 2000, you will see a message "The file "xxxxx.xxx" is required from the
Windows 2000 Professional CD-ROM" (where "xxxxx.xxx" is replaced with a file name such as
"courf.fon"). In this case, enter "c:\support\i386" in the [Copy from] field, and press [OK] to start
the setup. After completing the setup, install Windows 2000 Service Pack2.
1
Turn on the computer.
After a few seconds, [Starting the Windows Setup Wizard] is displayed.
2
Click [Next].
[License Agreement] is displayed.
This License Agreement describes the agreement for using preinstalled Windows on the computer.
3
Read the [License Agreement] carefully, and click [I agree], and then [Next].
Point
If you select [I do not agree], click [Next] and follow the instruction message.
4
Enter [Name] and [Organization] and click [Next].
You can skip [Organization].
[Computer name and administrator password] is displayed.
5
Fill out [Computer name], [Administrator password], and [Reenter password], and click
[Next].
[Setting up network] appears.
To set up the network, ask your network administrator to check the setup after completing the
setup, and set it up for your operating environment.
6
Click [Standard setting] and [Next].
Point
With [Standard setting], the following network components are installed.
Microsoft Network Client
Microsoft Network File and Printer Share
Internet Protocol (TCP/IP)
[Work group or domain name] appears.
26
Advertisement
Table of Contents
