Other Safety Precautions - FUTABA 4YWD Instruction Manual

CAUTION
Do not store your R/C system where it will be exposed to the following conditions.
• Extreme heat or coldness
• Exposed to direct sunlight
• Where humidity is high
• Where vibration is prevalent
• Where dust is prevalent
• Where there is steam and condensation
Storing your R/C system under adverse conditions could cause deformation and
numerous other problems with operation.
If the system will not be used for a long period of time, remove the batteries from
the model and store in a cool, dry place.
If the batteries are left in the model, electrolyte may leak and damage the model.
<NiCd/NiMH Battery Recycling>
battery by taking it to a battery recycling center.
CAUTION
When operating two or more models at the same time, have a third person act as a
spotter. They will be in charge of safety and you should follow their instructions.
Beginners should receive instructions regarding safety and operation from an
experienced modeler.
Always use only genuine Futaba transmitter, receivers, servos, and electronic speed
controls, along with other optional parts and components.
Futaba will not be held responsible for damages caused by other than genuine Futaba
parts and components. Use only genuine Futaba parts and components listed in the
instruction manual and catalog.
Never use the T4YWD/R214GF-E in GP models (engine models), model boat and air
models (airplane, helicopter, glider, etc.).
T4YWD/R214GF-E can be used only for electric model cars.
Do not short circuit the battery terminals.
Short circuiting the terminals will lead to sparks and overheating and could cause a
fire and burns as well.
Do not expose plastic parts to fuel, motor spray, waste oil or exhaust.
The fuel, motor spray, waste oil and exhaust will penetrate and damage the plastic.
<NiCd/NiMH Battery Electrolyte>
The electrolyte in NiCd/NiMH batteries is a strong alkali. Should you get even the smallest amount
or clothes, wash with water immediately.

Other Safety Precautions

7