Tc Central Main Menu Screen - Omega HHF1001A User Manual

5.2 TC Central
Once the wireless transmitter is set using the end device configuration software,
connect the wireless receiver (UWTC-REC1) to the PC USB port. Then run the
TC central software. The software will recognize and connect to the wireless
receiver. You can now monitor and log air velocity and air temperature from the
wireless transmitter (HHF1001x-W).
Figure 5-6 shows the main menu where air velocity, air temperature, and
wireless signal strength are displayed in real time. Please note that since the
HHF1000 is set for unit ID #1, it is displayed under Address 0001.
You can configure the left and the right Y Axis for air velocity and temperature
by clicking the options button. Figure 5-7 shows the configuration of the Y Axis.
You can chart and log data in real time. Simply click on the chart tab from the
main menu.
After configuring the Y Axis, click on the start button from the chart tab menu.
It will take you to the Data Plotting/Logging Menu selection as shown in Figure
5-8. In this menu, you can select chart sampling rate, line colors, plotting on left
and right axis, and the location of the data file. After you are done, click OK to
go back to the plotting screen. You will see the air velocity and air temperature
plots in real time as shown in Figure 5-9.
You can view the data log by clicking the Data Log tab. Figure 5-10 shows the
data log screen.
Figure 5-6. TC Central Main Menu Screen
Wireless PC Communications
5
5-5