Shindaiwa EB240 Owner's/Operator's Manual page 5

Assembling the Blower
WARNING!
Danger from rotating
impeller! Stop the engine before
installing or removing the blower
tubes! Never perform any mainte-
nance or assembly procedures on
this unit while the engine is running!
Place the blower upright on the
ground or on a sturdy work surface.
1. Grasp the blower tube as shown,
and push the tube over the blower
discharge port and locking pins.
2. Lock the blower tube to the blower
discharge port by rotating the tube
as shown.
3. Grasp the nozzle with the label
"TOP" positioned as shown, and
then push the nozzle over the
straight tube and locking pins.
4. Lock the nozzle to the straight tube
by rotating the nozzle as shown.
IMPORTANT!
Blower tube installation affects both
blower balance and performance! The
tube and nozzle are correctly installed
when the label "Top" is visible to the
operator during normal operation.
Push the blower tube
over the discharge port
and locking pin
24002
Locking Pin
Straight Tube
1
Rotate clockwise to lock
24003
2
Push the nozzle
Blower Tube
over the blower
tube and locking
pin
24004
Locking Pin
3
Nozzle
Rotate clockwise to lock
Label "TOP" must
face up
4
24005
5