Preparing To Maintain The Machine; Lifting The Machine - Toro WORKMAN GTX 07131 Operator's Manual

Preparing to Maintain the
Machine
1. Park the machine on a level surface.
2. Engage the parking brake, rotate the key switch to the
O position, and remove the key.
FF

Lifting the Machine

DANGER
The machine may be unstable when using a jack. It
could slip off the jack, injuring anyone beneath it.
• Do not start the machine while the machine is
on a jack.
• Always remove the key from the key switch
before getting off the machine.
• Block the tires when the machine is supported
by lifting equipment.
• Use jack stands to support the machine once
you have lifted the it.
Important: Whenever the machine is ran for routine
maintenance and/or diagnostics, the rear wheels of the
machine should be 25 mm (1 inch) off the ground, with
the rear axle supported on jack stands.
•
The lifting point at the front of the machine is at the front
of the frame behind the towing tongue
Figure 22
1. Front lifting point
•
The lifting point at the rear of the machine is under the
axle tubes (Figure 23).
1. Rear lifting points
(Figure 22).
28
Figure 23