Accessing The Hood; Removing The Seat Assembly; Installing The Seat Assembly - Toro WORKMAN GTX 07131 Operator's Manual

Accessing the Hood

Raising the hood
1. Lift up the handle of the rubber latches at each side
of the hood (Figure
2. Raise the hood.
Closing the Hood
1. Gently lower the hood onto the chassis.
2. Secure the hood by aligning the rubber latches onto the
latch anchors at each side of the hood
24).
Figure 24
(Figure

Removing the Seat Assembly

Push the seat assembly forward and lift the assembly upward
until the retainer brackets clear the seat-base panel
1. Seat-base panel
2. Seat assembly

Installing the Seat Assembly

Lower the seat assembly and ensure that the retainer brackets
latch into the seat-base panel
24).
1. Seat-base panel
2. Seat assembly
29
(Figure
Figure 25
3. Retainer brackets
(Figure 26).
Figure 26
3. Retainer brackets
25).