Washing Programmes - Zanussi ZWP 581 User Manual

• To change the timer delay period, you must
go through the "Stop" position
programme your cycle.
The lid will be locked during the delayed start
time. If you need to open it, you must first pause
the appliance by pressing the "Start/Pause"
pushbutton. After closing the lid again, press
the "Start/Pause"
Start of the programme
Press the "Start/Pause"
the cycle. The corresponding light will come on
green. It is normal for the programme selector
to remain stationary during the cycle. The light
corresponding to the current cycle is illumina-
ted.
+ : Prewash + Wash
+ : Rinses + Spin
: End of cycle
The drain pump can operate for a short
time when the appliance fills water.
Interrupting a programme
Adding washing during the first 10 mi-
nutes
Press the "Start/Pause"
corresponding light will flash green while the
Stand by: once the programme has fin-
ished after a few minutes the energy sav-
ing system is enabled with the pilot lights

Washing programmes

Programme / Type of washing
Cottons (30° - 90°) : White or colour, e.g.
normally soiled work clothes, bed linen, table lin-
en, body linen, towels.
Max. spin speed: 850 rpm for model ZWP581/
1000 rpm for model ZWQ5102,ZWQ5103/
1200 rpm for model ZWQ5122
Cotton Eco (40°and 60°)
colour, e.g. normally soiled work clothes, bed lin-
en, table linen, body linen, towels.
Max. spin speed: 850 rpm for model ZWP581/
1000 rpm for model ZWQ5102,ZWQ5103/
1200 rpm for model ZWQ5122
6
and re-
pushbutton.
pushbutton to start
pushbutton : the
1)
: White or
appliance is paused. The lid can only be
opened around 2 minutes after the washing
machine has come to a stop. Press the "Start/
Pause" pushbutton again to continue the
programme.
Modifying the programme in progress
Before making any changes to the current pro-
gramme, you need to pause the washing ma-
chine by pressing the "Start/Pause"
button. If the modification is not possible, the
"Start/Pause"
few seconds. If you still decide to change the
programme, you must cancel the current pro-
gramme (see below).
Cancelling the programme
If you want to cancel the programme, turn the
programme selector to the "Stop"
End of the programme
The washing machine stops automatically, the
"Start/Pause"
light "End of cycle"
only be opened around 2 minutes after the
washing machine has come to a stop. Turn the
programme selector to the "Stop" position
Remove washing. Unplug and close water inlet
tap.
switched on. By pressing any button the appli-
ance will come out of the energy saving status.
Load
5,5 kg Rinse hold, Quick, Prewash, Extra rinse,
Delay start
5,5 kg Rinse hold, Prewash, Extra rinse, Delay
start
pushbutton flashes red for a
position.
pushbutton goes out and the
comes on. The lid can
Available options
www.zanussi.com
push-
.