Operation; Engage - Gravely 885015 Operator And Parts Manual

WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
BEFORE EACH USE
Follow all maintenance and adjustments procedures.
See Maintenance on page 16 and Service and
Adjustments on page 17.
OPERATING THE BRUSH
1. Adjust the brush contact area. See Brush Contact
Adjustment on page 17.
2. Start the engine. Wait until the engine is running
smoothly before operating.
3. Adjust the angle of the brush. See Brush Angle
Adjustment on page 17.
4. Move the throttle lever to the fast position.
5. Engage the PTO (power take-off).

OPERATION

6. Place the brush the angle needed and sweep a
distance of 10 feet (3 m). Place the key switch in
the off position, wait for all moving parts to come to
a complete stop and remove the key from the
ignition.
7. Check the cleared area to determine if the brush is
clearing properly. If the brush needs adjustment,
follow the procedures in Service and Adjustments
on page 17.
8. Select the speed that best matches the sweeping
conditions.
SHUTTING OFF
1. Shut off the PTO.
2. Shut off the engine and remove the ignition key.
15