Removal; Rapid Adapter Kit - Gravely 885015 Operator And Parts Manual

WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
REMOVAL OF POWER BRUSH FROM
RAPID UNITS
1. Remove washer and lynch pin from Rapid adapter
kit (figure 17).
2. Remove power brush (item 1) from Rapid adapter
kit and double universal joint (item 2).
3. Remove double universal joint (item 2) from Rapid
adapter kit (figure 18).
4. Remove Rapid adapter kit from unit.
1
Engage
Attachment
Locking Pin

Rapid Adapter Kit 78510700

Washer &
Lynch Pin
Figure 17

REMOVAL

2
REMOVAL OF POWER BRUSH FROM THE
FOUR-WHEEL TRACTOR
WARNING: Unintentional startup or contact with
exposed components can cause severe
personal injury. Stop the engine, wait for all
parts to come to a complete stop, remove the
key from the ignition switch, and disconnect the
spark plug wire before performing any
maintenance, installation, removal, or
adjustment.
1. Remove cotter pin (item 23) and flat washer
(item 22) from the control rod (item 18) at the latch
release (figure 19).
2. Remove knob (item 17) from control rod (item 18).
3. Remove control rod (item 18) from the control rod
bracket (item 21).
4. Remove cotter pin (item 33) and push rod (item 32)
from adapter (item 25) and tractor.
5. Remove the locking collar from the PTO shaft. If the
universal joint has the locking collar that twists,
twist the locking collar in the direction of the arrows
and hold it. Pull the universal joint from the PTO
shaft.
6. Remove the cotter pins from the equipment latches.
Open the equipment latches.
13
Rapid Adapter Kit 78510700
Figure 18
2