7. Install control rod (item 18) to power brush (item 1)
with flat washer (item 22) and cotter pin (item 23)
(figure 12).
22 & 23
Adjustment
Contact
Equipment
Adjustment
Latch
INSTALLATION OF TWO WHEEL TRACTOR
COMPLETING KIT (KIT # 78502300)
1. Remove the nut and hex bolt that fastens the gear
shift control lever to the handlebar. Keep the nut
and hex bolt (figure 13).
2. Install control rod guide (item 11) on handlebar and
gear shift control with 1/2" x 2-34" hex bolt (item 10)
and the nut removed in step 1.
Remove original nut and
hex bolt and replace with
the hex bolt with item 10.
12
9
13
Contact
18
25
33
Cotter
Pin
Figure 12
Gear Shift
Control
11
Figure 13
3. Install grommet (item 12) in the control rod guide
(item 11).
4. Put the bushing (item 8) on the top right side
attachment adapter stud. Put the nut on the stud
and tighten (figure 14).
5. Install double universal joint (item 2) power brush
(item 1) shaft drive (figure 15).
8
32
11
Adapter Stud
Nut
Attachment
Adapter
Figure 14
2
Figure 15
Quick Hitch
Pin
Hitch Pin
Hole