Figure - Gravely 885015 Operator And Parts Manual

7. Separate the power brush from the tractor. Put the
universal joint on the drive shaft of the power brush.

(figure 10).

8. Keep the push rod, control rod and universal joint
with the power brush.
22 & 23
Equipment
Latch
REMOVAL OF POWER BRUSH FROM THE
GEAR TWO-WHEEL TRACTOR
WARNING: Unintentional startup or contact with
exposed components can cause severe
personal injury. Stop the engine, wait for all
parts to come to a complete stop, remove the
key from the ignition switch, and disconnect the
spark plug wire before performing any
maintenance, installation, removal, or
adjustment.
18
25
33
Cotter
Pin
Figure 19
1. Lower the stand on the tractor to keep the rear of
the tractor from falling to the ground when the
power brush is removed.
2. Remove cotter pin (item 15), flat washer (item 14),
and control rod (item 13) from the latch release
(figure 20).
3. Remove knob (item 9) from the control rod
(item 13).
4. Remove control rod (item 13) from control rod guide
(item 11).
5. Remove the lynch pin and washer from the quick
hitch pin (figure 20).
6. Separate tractor and the power brush. Put the
universal joint on the power brush drive shaft
(figure 15).
Washer &
Pivot
Lynch Pin
32
Quick Hitch
Pin
14
Latch
Release
14 & 15
Zerk
Figure 20
13