Safety Instructions; Mounting The Speakers / Wall And Ceiling Installation; Notes For Mounting The Speakers; Preventing Hearing Damage - K&F PASSIO User Manual

Hide thumbs Also See for PASSIO:

User manual (13 pages)

User manual (28 pages)

Table Of Contents

Table of Contents

User's Manual

3.1

Suspended loads pose a safety risk.

Only qualified technicians are permitted to perform the installation steps. Be sure to use

personal protective equipment at all times.

Warning

The technicians installing the speaker on site are responsible for and guarantee safe setup

and use.

Never use signal cables or power cords for suspending, aligning, or securing the systems.

Before installing, check the stability, strength, and materials of walls, ceilings, and boarding.

For example, use suitable rawlplugs for wall panels and make sure the strength is sufficient.

Note that the suspension points on the hall ceiling (i.e. shackles, attachment points, or

chain hoists) must comply with the DGUV regulations 17 and 18 or similar locally applicable

accident-control standards. The maximum load must have been certified by an authorized

expert.

Be sure to tighten all bolts and screws to the specified torque.

Unless otherwise stated, use only KLING & FREITAG original parts for mounting the speakers.

Never use other parts (in particular, parts not made by KLING & FREITAG).

Make sure all fittings used are suitable for the task at hand and meet all relevant safety

requirements.

Ensure that all connections are secured against coming loose and that only authorized,

statically tested and correctly sized supports, mounting equipment, wire ropes and chains are

used.

Be sure to always visually inspect all safety-related speaker and accessory components

before use. If there are signs of wear, cracks, or deformation, etc., replace the affected parts

immediately. Visual inspection also includes checking all screwed connections of supporting

components.

The information described here does not relieve the user of the duty to follow the given

safety requirements and legal regulations.

3.2

Mount the speakers securely. To avoid injury or damage, always be sure to mount the

speakers securely so that they do not fall.

Please note that speakers can move as a result of vibrations. To prevent them from falling

from their mounted position, they must be secured properly.

Warning

Run the cables in a way that nobody can trip over them.

3.3

Keep your distance from operating speakers. This equipment is capable of delivering sound

pressure levels in excess of 90 dB SPL, which may cause permanent hearing damage.

Caution

3.4