Monitorlink Picture Position - Mitsubishi WS-48315 Service Manual

[Convergence Circuit]
18. Fine Convergence
Measuring
Instrument
Test Point
Ext. Trigger
Measuring
Range
Input Signal
Input Terminal
CONVERGENCE MODE
Activate ........MENU-0-3-5-9
Misc. ........................."6"
Coarse........................"5"
Fine ..........................."4"
Color (R,G or B)......AUDIO
Item No..................VIDEO
Adjust/Move..........ADJUST
Cursor Toggle.........ENTER
Save & Exit.....MENU (twice)
[MonitorLink]

19. MonitorLink Picture Position

Measuring
Instrument
Test Point
Ext. Trigger
Measuring
Range
Input Signal
Input Terminal
CIRCUIT ADJUST MODE
Activate ........ MENU-0-3-5-7
Function .................AUDIO
Item No. .................VIDEO
Adjust Data ...........ADJUST
Save Data .... .........ENTER
Exit ..............MENU (twice)
Downloaded from www.Manualslib.com
MODELS: WS-48315 / WS-55315 / WS-65315
Purpose:
Symptom:
-----
SD Fine Adjustment
-----
1. Select an External Input, no signal.
2. Activate the Convergence Mode, Fine Red.
------
3. Use the Cursor to converge red on the green.
4. Select the Fine Blue mode.
-----
5. Use the Cursor to converge blue on the green.
6. Exit the Convergence mode.
NTSC -- None
HD -- HD sync
HD Fine Adjustment
Video & DTV Inputs
1. Supply an HD signal (sync only) to the DTV inputs and select DTV with the
2. Repeat SD Fine Adjustment Steps 2 through 6, in the HD mode.
Purpose:
Symptom:
1. Apply a MonitorLink source to the MLink input.
2. Select MLINK input as the signal source.
3. Enter the Service Adjust Mode.
4. Select the MISCDEV Function.
5. Use Items #474 and #475 to center the MLink picture on the screen.
6. Press ENTER and exit the Adjustment Mode.
MonitorLink Source
MLINK
manuals search engine
To converge red, green and blue at the edges of the screen
Color edging at the edges of the picture.
"Audio" button.
Note: If an HD signal is not available, use the Conv. HD with No Signal
Procedure.
CONV. HD WITH NO SIGNAL
1. MENU-0-3-7-0
2. Set DTV Port to 1080i
3. MENU (Twice)
4. INPUT select DTV inputs
5. MENU-0-3-5-9
After Adjusting, set the
DTV Port to AUTO
To position MonitorLink source picture on the screen.
MonitorLink picture not centered on the screen.
Page 41