Table of Contents
Advertisement
4
Holding the control panel and cable tube by its sides, remove the control panel and cable tube away from the system.
Figure 108. Removing right control panel
Next steps
Install the right control panel.
Related links
Removing the air shroud
Removing the cooling fan assembly
Installing the right control panel
Installing the right control panel
Prerequisites
Follow the safety guidelines listed in
Steps
1
Route the control panel cable and VGA cable through the side wall of the system.
2
Align the control panel with the control panel slot on the system and attach the control panel to the system.
3
Connect the VGA cable to the system board.
4
Connect the control panel cable to the system board and secure it using cable latch.
5
Using Phillips #1 screwdriver, install the screw that secures the control panel and cable tube to the system.
162
Dell EMC PowerEdge R740 Installation and Service Manual
Installing and removing system components
Safety
instructions.
Advertisement
Table of Contents
