Table of Contents
Advertisement
Figure 76. Installing the network daughter card
Next steps
1
Install the expansion card riser 2 or the rear hard drive cage, depending on the configuration of your system.
2
Follow the procedure listed in
Related links
Installing expansion card riser 2
Integrated storage controller card
Your system includes a dedicated expansion card slot on the system board for the primary storage controller card. The storage controller
card provides the storage subsystem for internal hard drives of your system. The controller supports SAS and SATA hard drives and also
enables you to set up the hard drives in RAID configurations as supported by the version of the storage controller.
Removing integrated storage controller card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the air shroud.
4
Remove the expansion card riser 1.
Steps
1
Using Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the system board.
2
Lift the integrated storage controller cable away from the integrated storage controller.
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Dell EMC PowerEdge R740 Installation and Service Manual
Installing and removing system components
129
Advertisement
Table of Contents
