D-Link AC1900 User Manual page 68

Section 4 - Con guration
DHCP Server
Enable or disable the DHCP server.
Status:
Enter the starting and ending IP addresses for the DHCP server's IP
DHCP IP Address
assignment.
Range:
Note: If you statically (manually) assign IP addresses to your computers
or devices, make sure the IP addresses are outside of this range or you
may have an IP con ict.
Enter the length of time for the IP address lease in minutes.
DHCP Lease Time:
Enable this feature to broadcast your network's DHCP server to LAN/
Always Broadcast:
WLAN clients.
Advanced Settings
You may set the port speed of the Internet port to 10 Mbps, 100
WAN Port Speed:
Mbps, 1000 Mbps, or
Enable or disable Universal Plug and Play (UPnP). UPnP provides
UPnP:
compatibility with networking equipment, software, and peripherals.
Enable to allow IPv4 multicast tra c to pass through the router from
IPv4 Multicast
the Internet.
Stream:
Enable to allow IPv6 multicast tra c to pass through the router from
IPv6 Multicast
the Internet.
Stream:
Click Save when you are done.
D-Link DIR-878 User Manual
Network (continued)
(recommended).
64