Cisco Firepower 4100 Series Hardware Installation Manual page 58

Install the FIPS Opacity Shield
Step 7
Attach the FIPS opacity shield to the cable management brackets using the four 8-32 x .375" countersink Phillips head
screws provided in the FIPS kit.
Figure 39: Attach the FIPS Opacity Shield to the Cable Management Brackets
1 FIPS opacity shield
Cable management bracket
3
Step 8 Attach the 15 TELs. For information on the procedure and correct placement of the TELs, see the Tamper Evidence
Label (TEL) Placement section (section 2.13 ) in the
document.
Step 9 Attach the power cable to the appliance and connect it to an electrical outlet.
Step 10 Press the power switch on the rear panel.
Step 11 Check the power LED on the front panel. See
green indicates that the appliance is powered on.
When you toggle the power switch from ON to OFF, it takes several seconds for the system to power down.
Note
During this time, the power LED on the front panel blinks green. Do not remove the power cable until the power
LED is completely off.
Step 12 See the quick start guide for your operating software for further configuration information:
Cisco Firepower 4100 Series Hardware Installation Guide
54
2 8-32 x .375" countersink Phillips head screws (2
per side)
FIPS 140-2 Non Proprietary Security Policy Level 2 Validation
Front Panel LEDs, on page 7
Mount and Connect
for a description of the power LED. Solid