Set Parameters; Installation Environment - Toshiba TOSVERT VF-AS1 Instruction Manual

■ Installation environment

5. Set parameters

Set parameters of the inverter after installation the PB unit. Refer to instruction
manual of the VF-AS1 (E6581301 or E6581442 or E6581528) VF-PS1(E6581386 or
E6581531) section 5.19, VF-AS3 (E6582062 section 6.15.4) about how to set
parameters.
[Parameter setting]
Title
Dynamic braking

selection
note1), note2)
Dynamic braking

resistance
Dynamic braking

resistor capacity
Overvoltage limit
operation level

(Regenerative
braking level)
Braking resistance

overload time
Install the PB unit in a well-ventilated indoor place
and mount in portrait orientation.
As PB unit uses a built-in cooling fan, at least leave
a space of 100mm or more above and below the
PB unit.
note) Do not install in any location where there is
Function
Setting









~ Ω
~ kW
~%
note3)
~ sec.
high humidity or high temperatures and where
there are large amounts of dust and metallic
fragments. If you are going to install the
equipment in any area that presents a
potential problem, please consult with your
supplier before doing so.
Adjustment range
Braking
ST-off
function
―
Disabled
Enabled (It is
Enabled
effective in trip
condition.) The
state of  trip
Disabled
is excluded.
Enabled
Enabled (It isn't
effective in trip
condition )
Disabled
１５
Ｅ６５８１４３６
Default setting
Overload
detect
―
protect
not protect
protect

not protect
protect
not protect
protect
not protect
According to
inverter model
According to
inverter model

