5-4
6. When cloning is completed, both radios reset themselves and turn their green LEDs off. The
source radio produces a "clone-exit" tone and displays "Clone Complete".
7. Turn both radios off.
8. Disconnect the cloning cable from both radios and turn them on for normal operation.
(programmable)
(programmable)
5.4.2
Error Codes
"ERR: Mismatch" - The model numbers or the code plug versions are not the same for both
radios. Cloning cannot be performed.
"ERR: Timeout" - Communication between the two radios was not established or was disrupted
during the cloning process. If this occurs, check the cloning cable and all connections. Repeat the
cloning procedure.
Radio Tuning, Programming, Cloning, PassPort Tone Options and Diagnostic Functions
On/Off
Knob
Side Button 1
Side Button 2
Side Button 3
(programmable)
Figure 5-3. Radio Side Button Locations