Roland VR-4HD Reference Manual page 5

Category Setting item
SYSTEM
AUTO SCAN
AUTO SCAN TIME
LCD BRIGHTNESS
MENU DISPLAY LEVEL
LEVEL METER DISPLAY
INPUT CH LEVEL DISPLAY
TALLY LABEL DISPLAY
NO SIGNAL BACK
UNFIT SIGNAL BACK
DEINTERLACE MODE
COLOR BAR OUTPUT
TEST TONE OUTPUT
AUTO OFF
PANEL LOCK
MONITOR BUTTON LOCK
TOUCH PANEL LOCK
FREEZE MODE
TOUCH PANEL CALIBRATION ([EXEC])
FACTORY RESET
VERSION
Value
OFF, ON
1–5–120 sec
LOW, HIGH
5–13–15
OFF, ON
OFF, ON
OFF, ON
BLACK, BLUE
BLACK, BLUE, THRU
WEAVE, BOB
OFF, ON
OFF, ON
OFF, ON
OFF, ON
OFF, ON
OFF, ON
ALL, SELECT
([EXEC])
—
Explanation
This sets the Auto Scan function on or off. When set to "ON, " channels 1 through 4 are
switched automatically.
When the Auto Scan function is on, this sets the video display interval.
This sets the brightness of the built-in monitor.
This adjusts the brightness of the menu display.
Setting this to "ON" displays a volume level meter on the built-in monitor.
Setting this to "ON" displays labels identifying the input signals on the built-in monitor.
Setting this to "ON" displays a tally border on the built-in monitor and in preview output.
This sets the background color of channels that have no video input.
This sets the background color of channels on which video of an incompatible format is
input.
When set to "THRU, " video in an unsupported format is output unchanged, allowing
confirmation of the status of the input signal. Note, however, that the video might contain
additional noise artifacts.
This specifies the method used when converting interlaced input video to progressive
video.
WEAVE: This joins the top field and bottom field in a single frame. This is optimal for video
that contains little movement.
BOB: This interpolates the top field and bottom field, and unites them in a single frame.
This is optimal for video that contains much movement.
Setting this to "ON, " a color bar is output.
Setting this to "ON" outputs a test tone.
This sets the Auto Off function on or off. When set to "ON, " the power to the VR-4HD is
automatically turned off if 240 minutes elapse with no operation performed on the unit.
This sets whether panel lock is enabled (ON) or disabled (OFF) for all controllers except the
[SYSTEM SETUP] button and the [VALUE] knob.
This sets whether panel lock is enabled (ON) or disabled (OFF) for the [INPUT] and [OUTPUT]
buttons.
This sets whether panel lock is enabled (ON) or disabled (OFF) for tap operations on the
built-in monitor.
This sets the operation mode for freezes.
This calibrates the tap points for the touch panel (the built-in monitor).
This returns the unit to its factory defaults.
This displays the version of the system program.
Menu List (Setup Screen)
5