JVC MX-GA9V Service Manual page 9

3.1.4 Removing the front panel assembly
(See Fig.8 ~ 11)
• Prior to performing the following procedure, remove the metal
cover and CD changer mechanism assembly.
(1) Disconnect the card wires from connector CN870,
and CN315 on the main board respectively.
(2) Remove the wire clamp and disconnect the wire from con-
nector CN703 on the amplifier board.
(3) Disconnect the wire from connector
former board.
(4) Remove the four screws F on the bottom of the body.
(5) Release the two joints a on the lower right and left sides of
the body using a screwdriver, and remove the front panel
assembly toward the front.
Amplifier board
Wire clamp
CN703
Transformer board
CN220
3.1.5 Removing the tuner board
(See Fig.12)
• Prior to performing the following procedure, remove the metal
cover.
(1) Disconnect the card wire from connector
board on the right side of the body.
(2) Remove the plastic rivet fixing the tuner board.
(3) Remove the two screws G on the back of the body.
CN871
CN220 on the trans-
Main board
CN870
CN871
CN315
Front panel
assembly
Fig.8
CN1 on the tuner
(Bottom) (Bottom) (Bottom)
Fig.9
Front panel assembly
Fig.10
Joint a
Fig.11
CN1
Plastic rivet
Fig.12
F
Joint a
Front panel assembly
Tuner board
Rear panel
G
(No.MB011)1-9