Table of Contents
Advertisement
SETUP (Continued)
SETTING THE TIME AND DATE
Use the CLOCK SET display to set the date and time.
TIME (HOUR, MINUTE, SECOND, AM/PM)
DATE (MONTH, DAY, YEAR)
DAY OF WEEK: Corrected
C
LOCK
SET
0
1–
0
1–20
02
TUE
1
2
:
0 0
:
A
O
PT I O
NS
O
SD
TYP
: E
OFF
T I ME
ADJ
US
T
:
SLAVE
TIME ADJUST (MASTER or SLAVE)
OSD TYPE (OFF, FULL or HALF)
CLOCK SET Display Format Description
1. Press the START/STOP button so that [CLOCK
SET] flashes on/off.
2. Press the SET button. The month flashes on/off.
3. Press the UP or DOWN button until the desired
number appears on the monitor.
4. Press the SET button. The day flashes on/off.
5. Press the UP or DOWN button until the desired
number appears on the monitor.
6. Press the SET button. The year flashes on/off.
7. Press the UP or DOWN button until the desired
number appears on the monitor.
8. Press the SET button. The hour flashes on/off.
9. Press the UP or DOWN button until the desired
number appears on the monitor.
10. Press the SET button. The minutes flash on/off.
11. Press the UP or DOWN button until the desired
number appears on the monitor.
12. Press the START/STOP button: the seconds will
start counting and the clock will start. [CLOCK
SET] will flash on/off again at this time.
13. To display the time/date you have set here on
the monitor screen, press the START/STOP but-
ton again to cause [OPTIONS] to flash, and then
proceed with step 2 in item on OSD TYPE on
page 14.
14. Press the START/STOP button three times.
• Make sure that letters [CLOCK SET] or
[OPTIONS] are not flashing.
13
Notes:
• Perform the same procedure as when setting the
time and date to make corrections after having
set them. The minutes flash on/off when the SET
button is pressed (in step 2 above).
• To record time and date on the tape, display them
on the monitor screen. If they are not displayed
automatically to
match the input
on the monitor, they cannot be recorded on the
date.
tape.
PHILIPS L TC3924/62 (E) QR34071
Advertisement
Table of Contents
