Table of Contents
Advertisement
SAFETY PRECAUTIONS
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This label may appear on the rear of the unit due to
space limitations.
The lightning flash with an arrowhead sym-
bol, within an equilateral triangle, is intended
to alert the user to the presence of uninsu-
lated "dangerous voltage" within the prod-
uct's enclosure that may be of sufficient
magnitude to constitute a risk of electric
shock to persons.
The exclamation point within an equilateral
triangle is intended to alert the user to pres-
ence of important operating and mainten-
ance (servicing) instructions in the literature
accompanying the appliance.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT OPEN COVERS. NO USER SERVICEABLE PARTS
INSIDE.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
WARNING
To prevent fire or shock hazard, do not expose
units not specifically designed for outdoor use
to rain or moisture.
Attention: Installation should be performed
by qualified service personnel only in ac-
cordance with the National Electrical Code or
applicable local codes.
Power Disconnect: Units with or without
ON-OFF switches have power supplied to the
unit whenever the power cord is inserted
into the power source; however, the unit is
operational only when the ON-OFF switch is
in the ON position. The power cord is the
main power disconnect for all units.
External Power Supplies
Use Only the Recommended Power Supplies.
Power supplies must comply with the
requirements of the latest version of IEC
65/VDE 0860. Substitutions may damage the
unit or cause a fire or shock hazard.
220-240 V, 50 Hz Power Cords
220-240 V, 50 Hz power cords, input and out-
put, must comply with the latest versions of
IEC Publication 227 or IEC Publication 245.
ATTENTION
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
WARNING:
proper CMOS/MOSFET handling precautions to
avoid electrostatic discharge.
NOTE: Grounded wrist straps must be worn and
proper ESD safety precautions observed when
handling the electrostatic-sensitive printed circuit
boards.
1
Unpack carefully. This is electronic equipment and
should be handled carefully.
Check to ensure that the following items are in-
cluded:
• Model number of unit.
If an item appears to have been damaged in ship-
ment, replace it properly in its carton and notify the
shipper. If any items are missing, notify your Philips
Communication,
Representative or Customer Service.
The shipping carton is the safest container in which
the unit may be transported. Save it for possible
future use.
2
If the unit ever needs repair service, the customer
should contact the nearest Philips Communication,
Security & Imaging Service Center for return autho-
rization and shipping instructions.
Service Centers
U.S.A. & Canada: 800-326-3270 (717-735-6300)
Mexico & Central America: 52-5-564-2726
Europe & Middle East: 011-32-1-440-0711
South America: 54-11-4956-0837
Asia Pacific Region: 011-65-481-4422
For additional information, see www.philipscsi.com.
ATTENTION
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
SENSITIVE
DEVICES
Electrostatic-sensitive device.
UNPACKING
Security
&
SERVICE
PHILIPS L TC3924/62 (E) QR34071
Use
Imaging
Sales
2
Advertisement
Table of Contents
