Saving Energy; Connecting Additional Equipment; Emergency Interrupt; User Guide - Philips 686 Operating Instructions Manual

Saving energy

You can choose between two methods of switching to
standby.
Normal method: Switch to standby using the
ton. The clock time remains displayed. If the clock has not
been set, '--:--' appears in the display.
To save energy: Press the
time disappears from the display.

Connecting additional equipment

You can also connect additional equipment to the
et. For instance: satellite receiver, decoder or camcorder.
You can connect a HIFI-stereo set to the sockets
(left channel) and
AUDIO OUT L

Emergency interrupt

Both the video recorder and the remote control have an
'Emergency interrupt' button. You can use the
ton to interrupt any function.
Whenever you have operating problems you can simply
interrupt the function and start again.
You can practise operating your set without any worries. No
matter which buttons you press, you cannot damage it.
4
STANDBY m
button twice. The clock
STANDBY m
EXT.2
(right channel).
AUDIO OUT R
STANDBY m

User guide

With OSD (On Screen Display) the corresponding functions
appear on the TV screen. The most important button-functions
but- are displayed at the bottom of the screen. For instance:
sock-
Throughout this instruction manual, use the following buttons
for these functions: 'Select', 'Enter'/'Adjust', 'Confirm'.
Select: Use the P r
Enter/Adjust: Use the
buttons.
Confirm: Use the
but-
DATE PROG START V/P END
01 01 20:00 21:30
------------------------
gTIMER CLEAR gCL
NEXT
-/+ 0-9 D/WgSELECT OK
or the P q button.
P r or the P q button, or the
button.
OK
0-9