Programming With 'Videoplus; Programming Recordings Manually; Clear A Timer Block - Philips 686 Operating Instructions Manual

Programming with 'VIDEOPlus+'

All the information required for a programming is encoded in
the VIDEOPlus+ code.
1
Switch on the TV set.
2
Press the button on the remote control.
TIMER k
3
With the digit buttons
to 9 digits) printed in your TV guide next to the start time of
a TV programme.
If you make a mistake, clear with the
VIDEOPLUS
ONCE
------------------------
D/WgSELECT
0-9
4
If you want to programme at daily or weekly intervals,
press the button until 'D-DAILY' (daily intervals) or
SELECT
'W-WEEKLY' (weekly intervals) appears on the TV screen.
The 'daily intervals' function can only be used for
recordings to be made from Mondays to Fridays inclusive.
5
Confirm the entries with the
appears on the TV screen.
Note: If you use VIDEOPlus+ for the first time for this TV
channel, the line 'SELECT PROG' appears when you confirm
the VIDEOPlus+ code. Instead of 'E2', select the programme
number for this particular TV channel, using the digit
buttons . Confirm with the
0-9
* Switch 'PDC' or 'VPS' (V/P) on or off with the
ton.
* If you wish to set a later end time for a recording, press
5
the button at step
P q
P q button you will add 15 minutes to the end time.
* If e.g.: '20:00' flashes in the display, please set the clock.
6
Finally, press the
OK
plete.
The data has been stored in a TIMER block.
12
, enter the VIDEOPlus+ code (up
0-9
button.
CLEAR (CL)
53124----
gCL
CLEAR
OK
button. The resultant data
OK
button.
OK
SELECT
. Each time you press the
button. Programming is now com-
7
Make sure that a cassette without erase protection has
been loaded. Switch to standby with the
ton.
A programmed recording will only function when the video
recorder is switched to standby with the
ton.
Note:
* VIDEOPlus+ Aerial-code numbers: With this video re-
corder, VIDEOPlus+ aerial-code numbers will be allocated
automatically.

Programming recordings manually

1
Switch on the TV set. Press the
2
With the P q
Press the
TIMER k
3
With the TIMER k
lect between the entries 'DATE' (date), 'PROG' (pro-
gramme number), 'START' (start time) and 'END' (stop
time).
With the
P q
you can enter or adjust data.
You can switch 'VPS/PDC' (V/P) on and off at step 'START'
with the
SELECT
You can select between 'D' (daily intervals) or 'W' (weekly
intervals) at step 'DATE' with the
4
Finally, press the
plete.
5
Make sure that a cassette without erase protection has
been loaded. Switch to standby with the
ton.
but-
Note:
* Clear a TIMER block: At step
that you want to clear, using the
Press the
CLEAR (CL)
If e.g.: '20:00' flashes in the display, the clock must be set.
TIMER k
or P r button, select a free TIMER block.
button.
, the C or the D button you can se-
or button or the digit buttons
P r
button.
SELECT
button. Programming is now com-
OK
1
select the TIMER block
P q or P r
button.
but-
STANDBY m
STANDBY m but-
button twice.
,
0-9
button.
but-
STANDBY m
button.