Saving energy
You can choose between two methods of switching to
standby.
Normal method: Switch to standby using the
button. The clock time remains displayed. If the clock has not
been set, '--:--' appears in the display.
To save energy: Press the
The clock time disappears from the display.
Connecting additional equipment
You can also connect additional equipment to the
et. For instance: satellite receiver, decoder or camcorder.
You can connect a HIFI-stereo set to the sockets
(left channel) and
AUDIO OUT L
4
STANDBY m
button twice.
STANDBY m
EXT.2
(right channel).
AUDIO OUT R
Emergency interrupt
Both the video recorder and the remote control have an
'Emergency interrupt' button. You can use the
button to interrupt any function.
Whenever you have operating problems you can simply
interrupt the function and start again.
You can practise operating your set without any worries.
No matter which buttons you press, you cannot damage it.
User guide
sock-
With OSD (On Screen Display) the corresponding functions
appear on the TV screen. The most important button-functions
are displayed at the bottom of the screen. For instance:
Throughout this instruction manual, use the following buttons
for these functions: 'Select', 'Enter'/'Adjust', 'Confirm'.
Select: Use the
P r
Enter/Adjust: Use the
buttons.
Confirm: Use the
DATE PROG START V/P END
01
01
20:00
21:30
------------------------
gTIMER CLEAR
gCL
NEXT
-/+
0-9
D/WgSELECT
OK
or the
P q
button.
P r
or the
P q
button, or the
button.
OK
STANDBY m
0-9