Programming With 'Videoplus; Programming Recordings Manually; Clear A Timer Block - Philips TYPE VR 175 Operating Instructions Manual

Programming with 'VIDEOPlus+'

All the information required for a programming is contained
encoded in the VIDEOPlus+ code.
1
Switch on the TV set.
TIMER k
2
Press the button on the remote control.
3
Please enter the VIDEOPlus+ code (up to 9 digits) printed
in your TV guide next to the start time of a TV pro-
gramme.
If you make a mistake, clear with the
button.
VIDEOPLUS
53124----
ONCE
------------------------
D/WgSELECT
0-9
4
If you want to programme at daily or weekly intervals,
SELECT
press the button until 'D-DAILY' (daily intervals)
or 'W-WEEKLY' (weekly intervals) appears on the TV
screen. The 'daily intervals' function can only be used for
recordings to be made from Mondays to Fridays inclu-
sive.
5
Confirm the entries with the
data appear on the TV screen.
Note: If you use VIDEOPlus+ for the first time for this TV
channel, the 'SELECT PROG' line appears when you
confirm the VIDEOPlus+ code. Select and confirm the
programme number for the TV programme required.
* If you wish to set a later end time for a recording,
P q
press the button at step
P q
the button you add 15 minutes to the time.
* If e.g.: '20:00' appears in the display, please set the
clock.
6
OK
Finally, press the
complete.
The data has been stored in a TIMER block.
8
CLEAR (CL)
gCL
CLEAR
OK
OK
button. The resultant
5
. With each press on
button. Programming is now
7
Make sure that a cassette without erase protection has
been loaded. Switch to standby with the
button.
A programmed recording will only function when the
video recorder is switched to standby with the
STANDBY m
button.
Note:
* VIDEOPlus+ Aerial-code numbers: With this video
recorder, VIDEOPlus+ aerial-code numbers will be al-
located automatically.

Programming recordings manually

1
Switch on the TV set. Press the
2
Select a free TIMER block. Press the
TIMER k
3
With the button you can select between the
entries 'DATE' (date), 'PROG' (programme number),
'START' (start time) and 'END' (stop time).
You can enter or adjust data. Confirm each entry with the
TIMER k
button.
You can select between 'D' (daily intervals) or 'W'
(weekly intervals) at step 'DATE' with the
4
OK
Finally, press the
been completed.
5
Make sure that a cassette without erase protection has
been loaded. Switch to standby with the
button.
Note:
* Clear a TIMER block: At step
block that you want to clear. Press the
button.
If e.g.: '20:00' appears in the display, the clock must be
set.
STANDBY m
TIMER k
button twice.
TIMER k
button.
SELECT
button. Programming has now
STANDBY m
1 select the TIMER
CLEAR (CL)
button.