Table of Contents
Advertisement
Remove
and empty
the storage
bin:
l
If the ice dispenser has not, or will not be used for a
week or more,
l
If a power failure causes ice in the bin to melt and
freeze together;
l
If the ice dispenser is not used regularly.
1. Pull the coverrng
panel out from the bottom
and
slide it to the rear.
III
OFF/ON Signal Arm '
2. Lift the signal arm so it clicks Into the OFF position,
Ice can still be dispensed,
but no more will be made.
3. Lift the front of the storage bin. Pull it out.
4. Empty the bin. Use hot or warm water to melt the
ice if necessary. Never use anyfhlng
sharp to break
up ice in the bin, This can damage
the bin and
dispenser
mechanism.
5. Wash with mild detergent.
Rinse wellDo
not use
harsh or abrastve
cleansers or solvents.
6. When replacing
the bin, make sure it is pushed in
all the way. Push the signal arm down to the ON
position to restart ice production,
The night
light uses
FV-
d
a heavy-duty
IO-watt
1-1
L,&$
bulb. When it burns out,
purchase
another from
your dealer
A swatch
underneath
the panel
turns the light on and
nff
V!
I,
Night
light
Switch
IU II
I
Changing light bulbs.. .
Before removing
a light shield for cleaning
or for
l
light
bulb behlnd
Ice maker:
replacing
a bulb, unplug
the refrigerator.
Use op-
- Remove the ice bin (see ice maker instructlons
plionce
bulbs only
page
1 01.
-Replace
with a 40-watt appliance
bulb.
- Replace
ice bin
Pull Out at the Botto
Light bulbs
behind
refrigerator
and freezer
control
consoles:
-Pull bottom
of panel straight out.
-Lift top of panel off supports.
-Replace
with a 40.watt appliance
bulb.
- Replace
panel in reverse order.
9 Light bulb above
crisper:
-Pull
top of the light shreld away from the back
wall.
- Ltft shield off base supports.
- Replace
with a 40.watt appliance
bulb.
- Replace
shield in reverse order.
l
Night light in dispenser
area:
(See above.)
- Reach for the bulb through the dispenser area.
- Replace
with a heavy-duty
IO-watt bulb.
11
Advertisement
Table of Contents
