Configuring The Online User Handshake Function - HP 5120 SI Series Security Configuration Manual

Configuring the online user handshake function

About the online user handshake function
The online user handshake function checks the connectivity status of online 802.1X users. The network
access device sends handshake messages to online users at the interval specified by the dot1x timer
handshake-period command. If no response is received from an online user after the maximum number
of handshake attempts (set by the dot1x retry command) has been made, the network access device sets
the user in the offline state.
If iNode clients are deployed, you can also enable the online handshake security function to check for
802.1X users that use illegal client software to bypass security inspection such as proxy detection and
dual network interface cards (NICs) detection. This function checks the authentication information in
client handshake messages. If a user fails the authentication, the network access device logs the user off.
Configuration guidelines
Follow these guidelines when you configure the online user handshake function:
To use the online handshake security function, make sure the online user handshake function is
•
enabled. HP recommends that you use the iNode client software and iMC server to ensure the
normal operation of the online user handshake security function.
If the network has 802.1X clients that cannot exchange handshake packets with the network access
•
device, disable the online user handshake function to prevent their connections from being
inappropriately torn down.
You must disable proxy detection before disabling the online user handshake function.
•
Configuration procedure
Follow these steps to configure the online user handshake function:
To do...
Enter system view
Set the handshake timer
Enter Layer 2 Ethernet interface
view
Enable the online handshake
function
Enable the online handshake
security function
NOTE:
When 802.1X clients do not support exchanging handshake packets with the device, disable the online
•
user handshake function on the device. If not, the device will tear down the connections with such online
users for not receiving handshake responses.
HP recommends that you use the iNode client software and iMC server to ensure the normal operation
•
of the online user handshake security function.
Use the command...
system-view
dot1x timer handshake-period
handshake-period-value
interface interface-type
interface-number
dot1x handshake
dot1x handshake secure
75
Remarks
—
Optional
The default is 15 seconds.
—
Optional
Enabled by default
Optional
Disabled by default