5 Self-Diagnosis Function
PJ-1614NXE PJ-2216NXE Maintenance Manual
NOTE
For an 87-inch spec, parameters for the No.5 and No.6 heads are also available.
5.5.6 CW Adjustment Menu
In this menu, you can adjust the gap between two heads.
To adjust the gap between two heads, you must first print out a Uni-D drawing and identify the difference
between the selected two heads. Then, you enter the difference for the relevant parameter. The actual
procedure is as follows.
1. Set paper as necessary.
2. After paper is set, the machine prints out CW adjustment check patterns.
3. Check the printed CW adjustment check patterns for the following points.
5-24
Downloaded From ManualsPrinter.com Manuals