Acknowledging Errors; Logged Events; Sunny Island Category (1Xx) - SMA SUNNY ISLAND 6.0H Operating Manual

SMA Solar Technology AG
Level Designation
4 Failure
5 Device defect
Treatment of Pending Errors upon Activation
During the activation procedure, all pending errors are acknowledged without the error being logged in the list 420#
Error history. Errors which are still pending are entered again after activation. Errors which were detected by the Sunny
Island before activation and are no longer detected after activation are shown in the list 420# Error history.
Autostart
The autostart function allows automatic restarts in the event of malfunctions. If the autostart function fails in the event of a
malfunction, the Sunny Island attempts to carry out the next autostart immediately. The number of autostarts is restricted.
If the Sunny Island is in operation without malfunctions for ten minutes, it resets the autostart counter.
When the maximum number of autostarts has been reached, the Sunny Island reacts as follows:
• The Sunny Island waits ten minutes.
• The autostart counter is reset.
• The Sunny Island attempts to perform an autostart.
• When the maximum number of autostarts has been reached, the Sunny Island waits again for ten minutes.

9.2 Acknowledging Errors

If a malfunction or failure occurs, the Sunny Island switches to standby mode. Once you have remedied the cause of the
malfunction, you can enable a restart of the Sunny Island by acknowledging the error.
Procedure:
1. Eliminate the cause.
2. Press the button on the Sunny Remote Control. This acknowledges the error.
3. Start the system (see Section 4.2, page 17).

9.3 Logged Events

9.3.1

Sunny Island Category (1xx)

No. Name
E101 Standby
E102 Startup
E103 Run
E104 RunExtGn
E105 RunExtGd
E106 RunGdFeed
E108 Silent
E110 ErrShutdown
Operating Manual
Display on Explanation
the Sunny
Remote
Control
Failure Device failure, the Sunny Island switches off. Troubleshooting,
acknowledgment of the error and manual restart necessary.
Defect The Sunny Island is defective and switches itself off. The Sunny Island must
be replaced.
Description
Waiting mode
Startup process
Operation
Operation with a generator
Operation on the utility grid
Feed-in grid operation
Silent mode
Shutdown due to error
9 Troubleshooting
SI60H-80H-BE-en-20 41