Performing A Remote Update Using Sunny Portal - SMA SUNNY ISLAND 6.0H Operating Manual

6 Data Storage and Firmware Update
6.7.3

Performing a Remote Update Using Sunny Portal

Automatic start of the Sunny Island
If the Sunny Island was in operation before the firmware update, the Sunny Island restarts automatically upon
completion of the firmware update.
Sunny Portal can make the current firmware available automatically. For this, Sunny Portal first transfers the firmware
update to the SMA Speedwire data module Sunny Island. Then, the SMA Speedwire data module Sunny Island
automatically transfers the firmware update to the SD memory card in the Sunny Remote Control. This transfer takes some
time.
Requirements:
☐ The Sunny Island must be registered in Sunny Portal.
☐ The SMA Speedwire data module Sunny Island of the type SWDMSI-NR10 must be installed in the system.
Firmware for SMA Speedwire data module Sunny Island
The required firmware for the SMA Speedwire data module Sunny Island will be available as of week 12/
2014.
☐ Sunny Home Manager must be integrated in the system.
☐ The Sunny Remote Control must be connected to the master.
Procedure:
1. Ensure that a writable SD memory card is inserted in the Sunny Remote Control and remains inserted.
2. Switch to installer mode on the Sunny Remote Control (see Section 5.4.1, page 28).
3. Set the parameter 250.33 UpdMode to Auto.
4. Set the parameter 250.34 UpdAutoTime to the desired firmware update time.
5. Activate the automatic update of the PV system in Sunny Portal (see the Sunny Home Manager user manual).
☑ Once the transfer to the SD memory card is complete, the Sunny Island updates automatically at the specified time.
The Sunny Island switches to standby mode and updates the firmware.
36 SI60H-80H-BE-en-20
SMA Solar Technology AG
Operating Manual