Cisco ASR 920 Series Configuration Manual page 31

Port-Shaper and LLQ in the Presence of EFPs
Command or Action
Step 9
bridge-domain bridge-domain-id
Example:
Device(config-if-srv)# bridge-domain 100
Step 10 exit
Example:
Device(config-if-serv)# exit
Step 11
service instance id ethernet
Example:
Device(config-if)# service instance 2 ethernet
Step 12 encapsulation dot1q vlan-id
Example:
Device(config-if-srv)# encapsulation dot1q
101
Step 13 bridge-domain bridge-domain-id
Example:
Device(config-if-srv)# bridge-domain 101
Step 14 exit
Example:
Device(config-if-srv)# exit
Step 15
end
Example:
Device(config-if)# end
Configuring Port Level Shaping on the Main Interface with Ethernet Flow Points
Purpose
Binds the bridge domain to the service instance.
Exits service instance configuration mode.
Configures an Ethernet service instance on an interface and
enters service instance configuration mode.
Defines the matching criteria to map 802.1Q frames' ingress
on an interface to the service instance.
Binds the bridge domain to the service instance.
Exits QoS policy-map class configuration mode.
(Optional) Exits interface configuration mode.
QoS: Policing and Shaping Configuration Guide (Cisco ASR 920 Series)
25