Maintenance And Cleaning - Ariston FI7 871 SC IX A AUS Reference Manual

MAINTENANCE AND
CLEANING
Make sure that the oven has
cooled down before carrying out
any maintenance or cleaning.
Do not use steam cleaners.
EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth.
If they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
• Do not use corrosive or abrasive detergents. If any of
these products inadvertently comes into contact with
the surfaces of the appliance, clean immediately with
a damp microfibre cloth.
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues. To
dry any condensation that has formed as a result of
cooking foods with a high water content, leave the
oven to cool completely and then wipe it with a cloth
or sponge.
CLEANING THE REAR WALL AND THE CATALYTIC PANELS
This oven is equipped with special catalytic liners that
facilitate cleaning of the cooking compartment thanks
to their special self-cleaning coating, which is highly
porous and able to absorb grease and grime.
These panels are fitted to the shelf guides: When
repositioning and then refitting the shelf guides,
make sure that the hooks at the top are slotted into
the appropriate holes in the panels.
REPLACING THE LAMP
1.
Disconnect the oven from the power supply.
2.
. Unscrew the cover from the light, replace the bulb
and screw the cover back on the light.
3.
Reconnect the oven to the power supply.
10
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
• Clean the glass in the door with a suitable liquid
detergent.
• The oven door can be removed to facilitate cleaning.
• The top heating element of the grill can be lowered
to clean the upper panel of the oven. Remove the
lateral shelf guides, then pull the heating element out
a little and lower it. To reposition the heating element,
lift it up, pulling it slightly towards you, making sure it
comes to rest on the lateral supports.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
To make best use of the catalytic panels' self-cleaning
properties, we recommend heating the oven to 200 °C
for around one hour using the "Convection Bake"
function. The oven must be empty during this time.
Then leave the oven to cool down before
removing any remaining food residues using
a non-abrasive sponge.
Please note: Using corrosive or abrasive cleaning agents,
stiff brushes, pan scourers or oven sprays could damage the
catalytic surface and compromise its self-cleaning properties.
Please contact our After-sales Service if you require
replacement panels.
Please note: Only use 25-40W/230V type E-14, T300°C
incandescent lamps, or 20-40W/230 V type G9, T300°C
halogen lamps. The bulb used in the product is specifically
designed for domestic appliances and is not suitable for
general room lighting within the home (EC Regulation
244/2009). Light bulbs are available from our After-sales
Service.
- If using halogen bulbs, do not handle them with your bare
hands as your fingerprints could cause damage. Do not use
the oven until the light cover has been refitted.
Download the Use and Care Guide from
www.aristonchannel.com for more information
Wear protective gloves.
The oven must be disconnected
from the mains before carrying
out any kind of maintenance
work.