Debug Commands - Alcatel-Lucent 7750 Configuration Manual

Interfaces

Debug Commands

lmi (frame-relay)
Syntax lmi [port-id]
no lmi
Context debug>frame-relay
Description This debug command enables tracing of all the LMI messages in both receive and transmit directions for one
or all of the Frame Relay interfaces. All types of Frame Relay interfaces are supported. If the port ID is not
specified, debug is enabled on all Frame Relay interfaces.
The no form of the command turns off LMI and Frame-Relay debugging, debug>frame-relay>no lmi and
debug>no frame-relay.
Parameters port-id — Specifies the ILMI-supporting port ID.
Syntax:
Sample Output
2959 2007/04/11 23:01:34.63 MINOR: DEBUG #2001 - FR
"FR: TX STATUS Msg on dce Port: 1/1/1 LMI: itu
FR Hdr: 00 01 03 08 00 7D
Rpt IE: 51 01 01 LINK_INT_VERIFY
KA IE: 53 02 31 45 TxSeqNo=49 RxSeqNo=69"
2960 2007/04/11 23:01:44.63 MINOR: DEBUG #2001 - FR
"FR: RX STATUS ENQ Msg on dce Port: 1/1/1 LMI: itu
FR Hdr: 00 01 03 08 00 75
Rpt IE: 51 01 01 LINK_INT_VERIFY
KA IE: 53 02 46 31 TxSeqNo=70 RxSeqNo=49"
ilmi (atm)
Syntax [no] ilmi port-id
Context debug>atm
Description This command enables debugging for ATM ILMI.
The no form of the command turns off ILMI and debugging,.
Parameters port-id — Specifies the ILMI-supporting port ID.
Values
Page 768
slot/mda/port[.channel]
slot/mda/port[.channel]
7750 SR Interface Configuration Guide