Philips AVENT SCF334 Manual page 20

English
20
CAUTION
-
Keep all components not in use out of the reach of children.
-
Do not alter the product or parts of it in any way. This may result in
unsafe functioning of the product.
Cautions to avoid damage to the product:
-
Do not place in a heated oven, plastic can melt.
-
Plastic material properties may be affected by disinfection and high
temperatures. This can affect the fit of the dome cap.
-
Do not leave a feeding nipple in direct sunlight or heat, or leave in
disinfectant for longer than recommended because this may damage the
product.
Before first use
Before first use, disassemble all parts, clean and optionally disinfect the
bottle. Inspect the bottle and feeding nipple before each use and pull the
feeding nipple in all directions to prevent a choking hazard. Throw away at
the first signs of damage or weakness.
Cleaning bottles
To ensure hygiene, clean the parts of the bottle mentioned in section
'Cleaning' before each use. Also clean all parts after each subsequent
use. You can optionally disinfect by following the instructions in section
'Disinfection (optional)' .
Make sure that you wash your hands thoroughly and that the surfaces are
clean before contact with cleaned components. Excessive concentration of
detergents may eventually cause plastic components to crack. Should this
occur, replace immediately. Inspect the bottle and feeding nipple before
each use and pull the feeding nipple in all directions to prevent a choking
hazard. Throw away any part at the first signs of damage or weakness.
Assembling bottles
When you assemble the bottle, make sure you place the dome cap
vertically onto the bottle so that the teat sits upright.
To remove the dome cap, place your hand over the dome cap and your
thumb in the dimple of the dome cap.