To Attach Trimming Guides; For Uniform Cutting; How To Give A Haircut - Remington HC2000 Series Use & Care Manual

7. Ensure the hair is dry. Hair clippers perform best with dry hair, making it
easier to see how much hair is being cut.

TO ATTACH TRIMMING GUIDES

1. Select an appropriate length trimming guide to match the desired length
of hair to remain after the cut. The trimming guides are numbered and
marked with 3mm, 6mm, 9mm, 12mm, 16mm, 18mm and 25mm.
2. Hold comb with teeth up, slide the attachment firmly onto the bottom
clipper blade.

FOR UNIFORM CUTTING

Allow the clipper to cut through the hair without forcing it at a faster rate, as this
may create a pulling sensation.
Use short strokes when cutting and initially use the longest trimming guide. You
can always use a closer trimming guide later if you want a closer cut.

HOW TO GIVE A HAIRCUT

1. Start at the back of the head. Holding the clipper as shown, lightly stroke
upwards making sure you are taking off the
desired amount of hair. Work your way up
to the crown of the head in layers. When
completed, comb the area to remove any loose
hair and determine if you need any further
cutting.
2. Repeat the same procedure for each side of
the head. Make sure the length of the hair is
trimmed the same on both sides of the head.
3. To cut the top of the head, hold the hair
between your fingers and cut a small amount
at a time. Cut from the front to the back.
4. To trim around the ears and short hairs at
the nape of the neck, you must remove the
trimming guide. Angle the clipper and lightly
stoke around each ear to the back of the neck.
Be careful not to touch ears or to press too
hard.
6