Hc2000 Series Specifications; Before Cutting Hair; Getting Started - Remington HC2000 Series Use & Care Manual

HC2000 SERIES SPECIFICATIONS

Power System
Voltage Type

BEFORE CUTTING HAIR

The blades of this clipper are designed to remain permanently lubricated. They
do not need oiling. We have aligned the blades on your hair clipper prior to
shipment. It is possible the blades may be bumped out of alignment whilst in
transit. Correct blade alignment is essential for effective cutting. If the blades
are out of alignment they can be easily adjusted.
1. The end of the top blade should be closer to the body of the hair clipper
than the bottom blade. This is important so that the clipper doesn't cut too
close or allow the moving (top) blade to touch the skin.
2. The bottom blade should be as closely aligned as possible to the centre of
the top blade.
3. If the blades are not correctly aligned, turn the clipper on for a few
moments, turn off and unplug. Loosen the two screws slightly and
manually adjust the bottom blade until it is aligned.
Re-tighten the screws.
4. Ensure the hair clipper is running smoothly, with a slight vibration, before
attempting to cut any hair.

GETTING STARTED

1. Make sure your clipper is operating correctly.
2. Place a cape around the neck of the person whose hair is being trimmed
or cut.
3. This person should be seated so that the top of their head is at your eye
level.
4. Comb the hair as it is normally styled.
5. Comb out all knots and tangles.
6. Hold the hair clipper in the palm of one hand and with your thumb resting
firmly on the top of the hair clipper. This grip proves comfortable cutting
control. Although the hair clipper may be used left or right handed, using it
right handed allows you to access the taper lever more easily.
Cord
Single 220-240V
5