Troubleshooting
Problem
No image or wrong image on TV1
No image or wrong image on TV2
Interference in the image on TV2
The video sources do not respond • Point the remote control directly to the receiver (B).
to the remote control commands
from TV2
The image of the video source
disappears on TV2
Tip
• Make sure the video source is connected to the transmitter (A).
• Make sure the transmitter (A) is connected to TV1.
• Make sure SCART cables are firmly inserted.
• Make sure the video source is switched on.
• Make sure the correct SCART input on TV1 is selected.
• Make sure SCART cables are firmly inserted.
• Make sure the receiver (B) is connected to TV2.
• Make sure both receiver (B) and transmitter (A) are switched on.
• Make sure the video source is switched on.
• Make sure the correct SCART input on TV2 is selected.
• If the video source gives proper image on TV1:
Make sure the video source gives video signal in CVBS mode.
> See its user manual
• Change the wireless channel that is used for communication.
> See the user manual (F) page 7.
• The receiver (B) is out of range of the transmitter (A).The number of
walls and ceilings in between the receiver (B) and transmitter (A) restrict
the distance.
• Slightly change the position of the receiver (B) or the transmitter (A).
• Change the wireless channel that is used for communication.
> See the user manual (F) page 7.
• The receiver (B) is out of range of the transmitter (A).The number of
walls and ceilings in between the receiver (B) and transmitter (A) restrict
the distance.
• Replace the batteries of the remote controls with new ones.
• Install the remote control blaster cord (E).
> See the user manual (F) page 6.
• The maximum operating distance of the remote control is 5 m.
• Turn off the auto standby mode of the video source.
> See its user manual.
• Follow the instructions to reconnect the video sources.
> See this quick start guide (D).