Re-Establishing Connectivity—Method 2 - Cisco CSR 1000v Series Software Configuration Manual

Installing Cisco CSR 1000v Licenses
DETAILED STEPS
Command or Action
Step 1 ip http client source-interface interface
Example:
Router(config)# ip http client source-interface GigabitEthernet1
Note The interface GigabitEthernet1 needs to have an IPv4 address, not an
IPv6 address.
Re-establishing Connectivity—Method 2
This task applies to the following Cisco IOS XE releases: 3.16.5 (or earlier), Everest 16.4.1, and Denali 16.3.1
to 16.3.3.
To establish a connection if IPv6 connectivity fails, choose one of the following two options:
• Use local DNS resolution using the ip host command.
• Specify static IPv4 addresses in the smart licensing call-home profile by performing the steps shown
below.
DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
Router# configure terminal
Step 2
service call-home
Example:
Router(config)# call-home
Step 3 call-home
Example:
Router(config)# call-home
Step 4
profile name
Example:
Router(config-call-home)# profile profile1
Purpose
Enters configuration mode.
Activates the call-home feature.
Enters the Call Home configuration submode.
Enters the Call Home destination profile configuration subm
for the specified destination profile. If the specified destina
profile does not exist, it is created.
Cisco CSR 1000v Series Cloud Services Router Software Configuration Guide
Re-establishing Connectivity—Method 2
Purpose
Configures the interface to use IPv4.
179