Select "I0dig" and confirm with "OK". Proceed in the same way for the output. At the end, click into the
free area of network "0001".
Compiling the project
The definition of the project is now completed and the project can be built. For this purpose, select the
menu item "Project/Rebuild all".
If no errors were detected, the message "0 errors, 0 warnings" is displayed in the message box.
Setting the communication parameters
In order to establish the connection between the PLC and the PC, the communication parameters have
to be set. We are using the COM2 interface of the PLC and the COM1 interface of the PC or the COM
interface of the PC assigned by the USB RS-232 converter. Switch to the
the object "PLC Configuration". In the configuration tree, click on the
"Interfaces[FIX]" element.
____________________________________________________________________________________________________________
G1
Introduction to AC500
symbol in front of the
1-88
tab. Double click
AC500 / Issued: 07.2006