How To Do An Otdr Test; Power The Tester; Select Settings - Fluke OptiFiber PRO OTDR Getting Started Manual

Do not look directly into optical connectors. Some sources
emit invisible radiation that can cause permanent damage
to your eyes.
 Button that controls the VFL.
Micro-AB USB port: This USB port lets you connect the tester to

a PC so you can upload test results to the PC and install
software updates in the tester.
Type A USB port: This USB host port lets you save test results on

a USB flash drive
or connect a Wi-Fi adapter for access to Fluke Networks cloud
services.
Headset jack.

 
display.
 Power key.
 
Connector for the ac adapter. The LED is red when the battery

charges, and green when the battery is fully charged. The LED
is yellow if the battery will not charge.
RJ45 connector: Lets you connect to a network for access to

Fluke Networks cloud services.
Decal with laser

safety information:

How to Do an OTDR Test

1. Power the Tester

Charge the battery if necessary. Connect the ac adapter to
ac power and to the adapter connector () shown in Figure
1. You can use the tester while the battery charges.

2. Select Settings

2-1 On the home screen, tap the test setup panel (see
2-2 On the CHANGE TEST screen, tap EDIT.
2-3 On the TEST SETUP screen, tap the panels to change

Networks products at:
,
connect the FI-1000 video probe to the tester,
: Starts a test. To start a test, you can also tap TEST on the
: Press

Figure 2).
settings:
Test Type: Select Auto OTDR.
ShopFlukeNetworks
W
Warning
to go to the home screen.
*
-continued-
1.800.561.8
.ca