DèLonghi ESAM6900 Instructions For Use Manual page 27

The coffee does not come out
of the spouts, but from around
the service door.
The coffee is delivered too
quickly.
Coffee does not come out of
one of the spouts.
Water comes out of the spouts
instead of coffee.
The milk
does not
come out
of the milk
spout.
The milk
contains
large
bubbles and
squirts out
of the milk
spout or
there is little
froth.
The milk
contains
large
bubbles and
there is little
froth
The appliance does not come
on
The holes in the spouts are clogged with dry
coffee dust.
The coffee guide inside the service door is blo-
cked and cannot swing.
The coffee is ground too coarsely.
The spouts are blocked.
The pre-ground coffee may be blocked in the
funnel (A8)
The milk container lid is dirty.
The milk is not cold enough or is not
semi-skimmed.
The froth adjustment dial is incorrectly
adjusted.
The milk container lid or froth adjustment dial
are dirty
The hot water/steam nozzle is dirty
The spout is dirty.
The milk is not cold enough or is not
semi-skimmed.
The steam nozzle has not been inserted after
cleaning.
It is not plugged into the mains socket.
The main switch is not turned on.
The button has not been pressed
sufficiently.
Clean the spouts with a toothpick, sponge or
hard bristled kitchen brush.
Thoroughly clean the coffee guide, particularly
near the hinges.
Turn the grinding adjustment dial one click
counter clockwise towards "1" while the coffee
mill is in operation (fig. 11). Avoid turning the
grinding adjustment dial excessively other-
wise when you select two cups, the coffee may
be delivered a drop at a time.
Clean the spouts with a toothpick .
Empty the funnel with the help of the brush
as described in the section "Cleaning the pre-
ground coffee funnel".
Clean the milk container lid as described in the
section "Cleaning the milk container".
Use skimmed or semi-skimmed milk at refrige-
rator temperature (about 5° C). If the result is
not as you wished, try changing brand of milk.
Adjust following the instructions in the section
"Making drinks with milk".
Clean the milk container lid and dial as de-
scribed in the section "Cleaning the milk
container".
Clean the nozzle as described in the section
"Cleaning the hot water/steam nozzle".
Clean as described in the section "Cleaning the
spout after use".
You should ideally use skimmed or semi-skim-
med milk at refrigerator temperature (about
5°C). If the result is not as you wished, try
changing brand of milk.
Replace all the spout components correctly.
Plug into the mains socket.
Place the main switch in the I position
Hold the button down for a few seconds.
26