Displayed Messages - DèLonghi ESAM6900 Instructions For Use Manual

DISPLAYED MESSAGES

DISPLAYED MESSAGE
FILL WATER TANK
GROUND TOO FINE ADJUST
MILL
INSERT WATER SPOUT
EMPTY GROUNDS CONTAINER
INSERT GROUNDS CONTAINER
ADD PRE-GROUND COFFEE
POSSIBLE CAUSE
Insufficient water in tank or tank not inserted
correctly
The grinding is too fine and the coffee is deli-
vered too slowly or not at all.
The water spout is not inserted or is inserted
incorrectly.
The grounds container is too full or more than
3 days have passed since delivery of the first
coffee (this guarantees correct hygiene of the
machine).
After cleaning, the grounds container has not
been replaced.
The "pre-ground coffee" function has been se-
lected without placing any pre-ground coffee
in the funnel.
The funnel (A8) is blocked.
SOLUTION
Fill the tank with water and/or insert it cor-
rectly, pushing it as far as it will go until it
clicks into place.
Repeat coffee delivery and turn the grinding
adjustment dial one click clockwise towards
"7" while the coffee mill is in operation.
If after making at least 2 coffees delivery is
still too slow, repeat the correction procedure,
turning the grinding adjustment dial another
click until delivery is correct.
If the problem persists, press OK to deli-
ver water from the spout until it flows out
normally.
Insert water spout as far as it will go.
Empty the grounds container and clean, then
replace.
Important: when removing the drip tray, the
grounds container MUST be emptied, even if it
contains few grounds.
If this is not done, when you make the next
coffees, the grounds container may fill up more
than expected and clog the machine.
Open the service door, remove the drip tray
and insert the grounds container.
Place pre-ground coffee in the funnel or dese-
lect the "pre-ground" function.
Empty the funnel with the help of the cleaning
brush as described in the section "Cleaning the
pre-ground coffee funnel".
23