Specifying The Remaining Length Of Thread; Selecting The "Eco Mode" Or "Shutoff Support Mode - Brother 884-T20 Operation Manual

a Touch and
The desired size is displayed.
• A value between 0 and 1 millimeters if the units of
measurements is set to "mm" (or a value between 0
and 0.04 inch if the units of measurements is set to
"inch") can be specified.
Note
• If the setting is changed from the previous
setting, the new setting is only applied to
the next embroidery.
Specifying the remaining length
of thread
This setting specifies whether the length of upper
thread that remains threaded through the needle
after the thread is trimmed (length of thread passed
through the eye of the needle) has a standard tail
or long tail.
When the embroidery machine is purchased,
"Standard Tail" is selected.
The setting for the remaining length of thread can
be specified from page 2 of the settings screen.
a Touch and
The desired length is displayed.
• If the machine misses stitches with a standard length
of thread after it is trimmed, select "Long Tail".
• When using metallic thread, select "Long Tail".
to select the stitch length.
to select the setting.
BASIC SETTINGS AND HELP FEATURE
Selecting the "Eco Mode" or
"Shutoff Support Mode"
You can save the machine power by setting the
eco mode or the shutoff support mode.
If you leave the machine without using for a
specified period of time, the machine enters in one
of these modes.
"Eco Mode";
Machine will enter a sleep mode. Touch the
screen or "Start/Stop" button to continue
embroidering.
"Shutoff Support Mode";
Machine will turn off after set period of time. Turn
machine off and then back on to restart
embroidering.
Condition Eco Mode
Available time OFF, 10 - 120
(minute)
"Start/Stop" button Green flashing
Suspended Machine light,
function Screen display
After recovering The machine starts
from the previous
operation.
Press the "Start/Stop" button or touch the screen
display to recover from these modes.
These settings can be specified from page 4 of the
settings screen.
a Use or to select the time until
entering the mode.
Note
• If you turn off the machine while the
machine is in the "Eco Mode" or the
"Shutoff Support Mode", wait for about 5
seconds before turning on the machine
again.
Shutoff Support
Mode
OFF, 1 - 12 (hour)
Green slow
flashing
All functions
6
You need to turn off
the machine.
185