Table of Contents
Advertisement
Chapter 10
10 1
LAN Settings
10 1 1
Change the LAN IP Address
The router is preset with a default LAN IP 192.168.1.1, which you can use to log in to
its web management page. The LAN IP address together with the Subnet Mask also
defines the subnet that the connected devices are on. If the IP address conflicts with
another device in your local network or your network requires a specific IP subnet, you
can change it.
Follow the steps below to change your IP address.
1
Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2
Go to
Advanced
3
Type in a new
IP Address
4
Select the
Subnet Mask
the IP address identifies the local IP subnet.
5
Keep
IGMP Snooping
listening to IGMP (Internet Group Management Protocol) network traffic. The
function prevents hosts on a local network from receiving traffic for a multicast
group they have not explicitly joined.
6
You can configure the router's
which you can also access the web management page.
7
Leave the rest of the default settings as they are.
8
Click
Save
to make the settings effective.
10 1 2
Use the GPON Router as a DHCP Server
You can configure the router to act as a DHCP server to assign IP addresses to its clients.
To use the DHCP server function of the router, you must configure all computers on the
LAN to obtain an IP Address automatically.
>
Network
>
LAN Settings
appropriate to your needs.
from the drop-down list. The subnet mask together with
as enabled by default. IGMP snooping is the process of
Second IP
page and select IPv4.
and
Subnet Mask
for LAN interface through
39
Advertisement
Table of Contents
