Mounting Options; Product Dimensions - Raymarine ray50 Mounting And Getting Started

Hide thumbs Also See for ray50:

Installation and operation instructions manual (116 pages)

Mounting and getting started (24 pages)

Troubleshooting manual (60 pages)

Table Of Contents

Table of Contents

Enlarged version

Ventilation requirements

To provide adequate airflow:

• Ensure that equipment is mounted in a compartment

of suitable size.

• Ensure that ventilation holes are not obstructed.

• Ensure adequate separation of equipment.

Mounting surface requirements

Ensure units are adequately supported on a secure

surface. Do NOT mount units or cut holes in places

which may damage the structure of the vessel.

Cable routing requirements

Ensure the unit is mounted in a location which allows

proper routing and connection of cables:

• Minimum cable bend radius of 100 mm (3.94 in) is

required unless otherwise stated.

• Use cable supports to prevent stress on connectors.

Warning: Protect unused

cables

Unused cables and wires should be

protected from water ingress and from

making contact with metal that may be

grounded.

• If supplied, use protective boots to ensure

that cables that are not connected are

protected.

• NEVER leave bare ended wires

uncovered/unprotected as this could

cause a short circuit and can induce

galvanic corrosion.

Electrical interference

Select a location that is far enough away from

devices that may cause interference, such as motors,

generators and radio transmitters/receivers.

Power supply

Select a location that is as close as possible to the

vessel's DC power supply. This will help to keep cable

runs to a minimum.