Raymarine ray50 Mounting And Getting Started page 15

SeaTalk ng® connection
The product can interface with Raymarine
or GNSS receivers and Raymarine
displays using the SeaTalk ng® connection.
1
3
5
6
ng
SeaTalk
1. Ray50 / Ray52 / Ray60 / Ray70
2. Optional Raymic handset station (Ray70 and
Ray70 only)
3. Optional 3 rd party passive speaker
4. Loud hailer (Ray70 only)
5. GPS Receiver
6. Raymarine ® Multifunction display (MFD)
A Raymarine ® SeaTalk ng® GPS or GNSS receiver
cannot be connected directly to the product, as GPS
and GNSS receivers are powered via the SeaTalk
backbone.
Connecting SeaTalk
Before connecting to SeaTalk
® GPS
SeaTalk ng®
® multifunction
maximum permitted Load Equivalence Number (LEN),
for the SeaTalk
product is connected.
2
4
D13293-1
1. Rotate the SeaTalk
anti clockwise, to the unlocked position.
2. Ensure the spur cable connector is correctly
orientated.
3. Fully insert the spur cable connector into the
SeaTalk
4. Rotate the locking collar clockwise 2 clicks, to the
locked position.
ng®
ng®
ng® , refer to the
Reference Manual, to ensure that the
ng® backbone is not exceeded once this
ng® connector's locking collar
ng® connector on the unit.
NMEA 0183 connection
The NMEA 0183 wires can be used to connect the
unit to a 3 rd party GPS/GNSS receiver or multifunction
display.
1
2
3
4
1. Yellow – Receive positive (+) wire.
2. Green – Receive negative (-) wire.
3. White – Transmit positive (+) wire.
4. Brown – Transmit negative (-) wire.
The NMEA wires should be connected to a compatible
NMEA 0183 device as shown in the table below:
NMEA 0183 wires
Yellow – Receive positive
(+)
Green – Receive negative
(-)
D13218-1
White – Transmit positive
(+)
Brown – Transmit negative
(-)
Connecting an antenna
The radio must be connected to a suitable antenna (not
supplied). The antenna connection must be protected
so it cannot come into contact with any bare metal
+
-
+
-
D13219-1
NMEA 0183 device
to
Transmit positive (+)
to
Transmit negative (-)
to
Receive positive (+)
to
Receive negative (-)
15