Starting And Stopping Scan; Responding To A Scan - RCA BRM300DV Instruction Manual

BRM300D
• Auto Scan: Your radio automatically starts
scanning when you select a channel / group
that has Auto Scan enabled.

Starting and Stopping Scan

Press the programmed Scan ON/OFF button to
start or stop the Scan. OR - Follow the procedure
below:
1. Use the Channel Selector Knob to select a
channel programmed with a scan list.
2. Press [VK] to access the menu.
3. Press [▲] or [▼] to navigate to Scan and press
[VK] to select.
4. The display shows Turn Off if scan is disabled
or the display shows Turn on if scan is enabled.
5. Press [VK] to select.
6. The LED blinks red and the Scan icon is
displayed when Scan is enabled. The LED turns
off and the Scan icon disappears when Scan
Professional Digital Two-Way Mobile Radio Instruction Manual
TM
Copyright © 2015 RCA Communications Systems
is disabled.

Responding to a Scan

During scanning, your radio stops on any
channel / group where activity is detected. After
the transmission is over the radio remains on the
active channel for a programmed time period
known as "hang time".
1. Press the PTT button during "hang time" to
respond to the call. The LED lights up red.
2. Release PTT button to listen.
Note: If you do not respond within the "hang
time" period, the radio continues scanning other
channels / groups.
Deleting a Nuisance Channel
If a channel continually generates unwanted
calls or noise (termed a "nuisance" channel),
you can temporarily remove the unwanted
channel from the scan list.
Note: This capability does not apply to the
45